The system comprises two voted receivers (only one is active at present) and audio is fed to the transmitter site where it is voted.
Transmitter is 50W into a 5/8 vertical.
Output: 29.680MHz
Input: 29.580MHz
A 91.5Hz tone is required at this stage due to some local interference I am working on rectifying at one of the receiver sites.
Regards
Hayden VK7HH
Re: VK7RHF 29.680MHz 10m Repeater
VK3ALB > 05-12-2016, 12:48 PM
Thanks Hayden,
About 5x5 here on a dipole.
Re: VK7RHF 29.680MHz 10m Repeater
VK7HH > 06-12-2016, 12:55 PM
Excellent, thanks Lou for trying. Hopefully it gets use during the openings this summer.
Re: VK7RHF 29.680MHz 10m Repeater
VK2HRX > 06-12-2016, 04:24 PM
Just heard it in Sydney on a horizontal 40m loop. Trying to figure out how to add a tone to my HF rig to see if I can get in.
Re: VK7RHF 29.680MHz 10m Repeater
VK7HH > 10-12-2016, 09:25 PM
Hi Compton,
I've got receiver noise at one of the sites that is stopping me from running it open mute.
Once I fix that issue, hopefully tone will not be required except under the most noisiest of conditions (band open to pirate stations North of Australia).
Re: VK7RHF 29.680MHz 10m Repeater
VK2HRX > 12-12-2016, 09:35 PM
Had a chat to Hayden, 7HH on it today late AM. Was peaking at S3 here in Sydney.
Re: VK7RHF 29.680MHz 10m Repeater
VK7HH > 13-12-2016, 08:51 AM
Good signal from you Compton on your 40m H loop.
Just been working on eliminating the need for tone... was at the receiver site yesterday when you called.